Instant adhesive for very strong welds. One drop is enough for even the most demanding jobs. It spreads precisely. Ideal for sticking small areas (not ideal for large surfaces). Bonds almost all hard and flexible materials, such as leather, many plastics, such as hard PVC (Polyvinyl Chloride), ABS (Acrylonitrile - Butadiene - Styrene), PS (Polystyrene), Plexiglas® acrylic resin, polycarbonate (Makrolon®), phenolic resins ( Bakelite®), porcelain, ceramics, wood, metal, cork, felt, fabric (test the appropriate one first), rubber. Only partially suitable for glass (over time the adhesive becomes brittle and weakens). Cyanoacrylate adhesives harden extremely quickly in the presence of moisture (such as air moisture, skin moisture, perspiration, sebum, tears). For this reason, you must be careful during use, especially with regard to children and contact with the skin and eyes. But even without treatment, cyanoacrylate adhesives naturally dissolve over time. If the skin sticks, wet as much as possible with warm soapy water and peel off carefully without using force. Moisturize the skin afterwards. Another possibility is to rub the fingers in warm water and press a paper clip or wire together. After a while the fingers can be separated. Acetone or nail polish remover can also be used. As organic solvents also remove grease, we recommend using hand cream afterwards. If any glue remains, these can be cleaned with a pumice stone. In case the product is sprayed into the eyes or mouth, they should be kept open and flushed with plenty of water. If necessary, seek medical advice.